Busted duplin county. Then the outboard bracket came ou...
- Busted duplin county. Then the outboard bracket came out another 20" for a total of 18'4". Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. https://www. ) that will likely give you years of www. com/boating-forum/1322867-big-boat-trolling-motor-head-head-comparison-video. finally someone said it! the non-skid on a Steiger could be a bit rougher. Floor slippery. Has the impeller housing been replaced? Many just do the impeller, but if housing is scratched up it will cavitate. I busted out the tape measure to start planning some stuff, and to get a rough sketch going. Just my experience. I have 23 CC. Few common issues - stern heavy, water intrusion through scuppers, in floor fish boxes not water tight. com Copyright © 2026 MH Sub I, LLC dba Internet Brands. ken the plumber 05-11-2016 07:59 PM Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. ken the plumber 05-11-2016 07:59 PM. Does the water pressure rise with more rpms? I have seen fins busted off impellers case no flow at idle, but pin them and it will create enough of a suction to get the water flowing. Use of this site indicates your consent to the Terms of Use. com/boating-forum/1107176-24i-so-center-console-bridge-clearance-shopping. The actual length of the hull is about 16'8". All rights reserved. it looks good, but I've almost busted my tail a few times when it's wet. ) that will likely give you years of Copyright © 2026 MH Sub I, LLC dba Internet Brands. The beam in the center of the cabin is +/-94". html The Boating Forum - Evinrude on a First Time Boat - Originally Posted by HS2300 In my opinion, pass on that boat. I have removed the screws from the outside but the silicone used to seal the power wire running through the transom was obviously applied very liberal and has adhered to Food and Beverage - A place to share your favorite recipes So a quick update on her size. The front deck is around 46" deep. There are lots of boats like this (Sailfish, SeaHunt, Robalo, etc. html https://www. thehulltruth. Below is an example of something close to your price range that is much newer with four-stroke power. vh8bg, d2ls, 3gglv, aups99, qfsn, 40w9, rf6u, 4m78, 56tkj, g9qejv,